Filter
Top Products
24
Partially Turn On the Perimeter
I have this feature.
I do not have this feature.
This feature requires a passcode.
This function is used to turn on the perimeter of your building while selected
portions of the perimeter remain turned off. Perimeter points that are not secure
(faulted) when this function is entered are not included in the system. This
function does not turn on the interior of your building. Entry/exit delays are
provided with this arming command.
Application
Use this function in residential systems to turn on the front of your house while
the interior and the rear perimeter doors are turned off, giving you freedom of
movement between the house and patio.
In commercial systems, when you need access to the large overhead doors to
receive deliveries, this function allows you to keep the rest of the building
perimeter armed.
COMMAND 8
To arm with COMMAND 8:
1. Ensure the keypad is disarmed.
2. Decide which points are to be left disarmed. Fault the points
(doors and windows) by leaving them open. The point(s) must
remain open until after the exit delay time expires.
3. Press the [COMMAND] bar. The Command mode indicator light
comes on.
4. Press the [8] key. The PERIMETER indicator light begins to flash,
showing the system has begun exit delay time. When the exit delay
expires, the PERIMETER indicator is continuously lit.
5. When performing a COMMAND 8, and no points are faulted, or
the points return to normal before the exit delay time expires, the
system is armed as in COMMAND 3.
6. To disarm your security system or cancel COMMAND 8, enter
your personal passcode and press [ENT].