Filter
Top Products
Your ProHeat 2X machine comes equipped with a
flex hose and at least one cleaning tool for cleaning
stairs, upholstery, and more.
1. Important! If using to clean upholstery, check upholstery tags.
A. Check manufacturer’s tag before cleaning. “W” or
“WS” on the tag means you can use your ProHeat 2X.
If the tag is coded with an “X” or an “S” (with a
diagonal stripe through it), or says “Dry Clean Only”,
do not proceed with any deep cleaning machine. Do
not use on Velvet or Silk. If manufacturer’s tag is
missing or not coded, check with your furniture dealer.
B. Check for colourfastness in an inconspicuous place.
C. If possible, check upholstery stuffing. Coloured
stuffing may bleed through fabric when wet.
D. Plan activities to allow upholstery time to dry.
E. Vacuum thoroughly to pick up loose debris and pet
hair. Use a vacuum with a brush attachment and a
crevice tool to clean in fabric folds.
2. Follow the instructions on pages 9 & 10 for filling the
2-in-1 water tank and the formula tank.
3. Set Ready Tools dial to the hose attachments setting.
This will allow spray and suction from the flex hose.
4. Set Custom Clean dial for heavy traffic, normal clean,
light clean, or rinse, as desired
5. Attach the cleaning tool to the end of the hose.
6. Plug in and turn on the power switch.
Note: The built-in heater heats the cleaning
formula for carpet and hard floor application
only. It does not heat the cleaning formula
through the accessory tools.
7. Clean by pressing the spray trigger to spray formula
onto the area to be cleaned. Slowly move the tool back
and forth over the soiled surface. Release the spray
trigger to suction soiled water. Continue to clean in the
area, working in small sections, until no more dirt can
be removed. Rinse (optional) and suction as needed.
Caution: Do no overwet.
8. Remove and rinse tools in clean, running water.
Dry and replace in the tool caddy.
9. It is recommended that you suction clean water
from the tap to rinse out the flex hose.
10. Before replacing, lift end of flex hose and stretch
out to ensure all water is cleared from flex hose.
11. Coil flex hose around the tool caddy.
12. Empty 2-in-1 water tank and rinse out, following the
instructions on page 11.
13. Return Ready Tools dial to floor setting.
Cleaning with Attachments
14
www.bissell.com
Adsdfdd ghg bvh
cvbbj jkn hnbj jkvh
gcghhjj jhffhl kllgh
Manufacturer’s tag
WARNING:
To reduce the risk of
injury, be extra careful
when cleaning stairs.
Make sure machine is
secure and level.
5
9 10
ug310-5880_9200E_406.indd 14ug310-5880_9200E_406.indd 14 6/9/06 4:25:42 PM6/9/06 4:25:42 PM