Filter
Top Products
26 Maintaining Your Appliance
© Travis Industries 100-01157 4041116
Monthly Maintenance (while appliance is in use)
Make sure the appliance has fully cooled prior to conducting service.
Door and Glass Inspection
The door can be lifted off the hinges if extensive repairs are conducted.
The door must form
an air-tight seal to the
firebox for the stove
to work correctly.
Inspect the door
gasket to make sure it
forms an air-tight seal
to the firebox.
Severely frayed or thread-bare
gasket should be replaced.
Use wood stove gasket
cement to re-adhere
loose gasket.
If the glass is damaged, replace
it - see “Replacement Parts” for
details.
High-Temperature anti-sieze
may be used on the door
hinges to eliminate squeaks.
The door latch should pull the door
against the face of the stove (but
not so tight as to not allow full
handle rotation). If the latch
requires tightening, remove a
washer between the door cam and
door frame. If the latch is too tight,
add a washer between the door
cam and door frame.
Door Frame
Door Handle
Nut
Door Cam
Washers
Note flat portion on bottom of door handle shaft.
Creosote - Formation and Need for Removal
When wood is burned slowly, it produces tar and other organic vapors, which combine with expelled
moisture to form creosote. The creosote vapors condense in the relatively cool chimney flue of a slow-
burning fire. As a result, creosote residue accumulates on the flue lining. When ignited, this creosote
makes an extremely hot fire. The chimney and chimney connector should be inspected at least once
every two months during the heating season to determine if a creosote buildup has occurred. If creosote
has accumulated, it should be removed to reduce the risk of a chimney fire.
If you are not certain of creosote inspection, contact your dealer or local chimney sweep for a full
inspection. Excess creosote buildup may cause a chimney fire, that may result in property damage,
injury, or death.