Filter
Top Products
14 Installation (for qualified installers only)
© Travis Industries 100-01157 4041116
Face Installation
There are several face options available for this fireplace insert. They all install with hooks that allow the
face to be hung on the fireplace insert. Follow the directions below to install the face, bypass handle, air
control handle, and door handle cover.
Face Installation:
The face has four hooks that
hang on the cast-iron tabs
near the door hinges. When
installing, make sure the
hooks insert fully and lock
into place.
Air Control Handle
Un-Screw the air control handle (with
rod) from the air control.
Install the air control knob, bypass control knob, and handle shield following the directions below.
Air Control Handle
Screw the air control handle
(with rod attached) onto the
air control.
Bypass Knob
Screw the bypass knob onto the
damper control rod.
Handle Shield Installation
Use the two nuts (included with
the face) to secure the handle
shield and emblem to the right
side handle.
NOTE:
There may be a slight gap
between the emblem and shield
after installation (this is normal).