Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
F232085
30
Steam Requirements
Steam Heat Option Only
The optional steam connection is located at the upper
right corner panel, as seen from the rear.
For washer-extractors equipped with optional steam
heat, install piping in accordance with approved
commercial steam practices. Steam requirements are
shown in Table 9.
NOTE: Failure to install the supplied steam filter
may void the warranty.
Never touch internal or external steam
pipes, connections, or components. These
surfaces can be extremely hot and will
cause severe burns. The steam must be
turned off and the pipe, connections, and
components allowed to cool before the
pipe can be touched.
SW014
WARNING
UW 2 Speed Pocket Hardmount
Steam Supply Information
Steam inlet connection, in. (mm) 1/2 (DN13) 12.7
Number of steam inlets 1
Recommended pressure, psi (bar) 30 – 80 (2.0 – 5.4)
Maximum pressure, psi (bar) 80 (5.4)
Table 9