Filter
Top Products
9
Once a transmitter is programmed into an address, the transmitter address will briefly turn off
whenever a transmission from that transmitter is received. This can be used to verify that the
correct transmitter has been programmed and is operating reliably.
NOTE: The current status of each transmitter is ignored by the controller while the receiver is
in Set Up mode.
RESET MEMORY
To erase all transmitters from memory and to reset to the factory default configuration, press
and hold both the Set and Mode/Advance switches simultaneously for 2 seconds. You are first
prompted to enter a code (as mentioned above). After the code is entered, the display will
show "EE". If you choose to continue, press and hold the Set and Mode/Advance switches
simultaneously for 2 seconds once again. Memory is reset at the end of the two seconds.
NOTE: If you choose not to reset memory at the "EE" display, don't press any keys for a 10
second period and the receiver will return to Run mode.
SET UP
When using a Model AEG-WR Wireless Receiver, it first must be enabled. This option can be
enabled by the installer in the Installer Setup menu.
INSTALLER SETUP:
1=CTRL 2=ZONE 3=DCM ↓
From the Installer Setup menu, select the 2 (ZONE) key.
If used with an Aegis, press 2 (RCVR), then ' # ' to enable the AEG-WR Wireless Receiver.
ZONE EXPANSION: 0
0=NONE 1=H/W 2=RCVR ↓
If used with an Aegis, you must set the Number of Expansion Enclosures.
NUMBER OF EXP ENCL: 0
1-4
If you are using 1-16 transmitters, enable only 1 Expansion Enclosure. If you are using 17-32
transmitters, enable 2 Expansion Enclosures, etc.