Filter
Top Products
5
Place the cover on the receiver and install the antenna onto the antenna connector. Connect the
receiver to the controller using 4 conductor 22 gauge or larger wire as follows:
OPERATION
The two operating modes of the receiver are "Run" and "Set Up".
In Run mode, with the receiver connected to the controller, the Mode LED should blink once
per second. The receiver monitors the status of each transmitter. If the status condition of a
transmitter changes, it is reported to the receiver and the information is updated on the LED
display.
The transmitter number flashes on the display whenever a transmission is received from a
transmitter. The display will continually display the status of any transmitters that are violated