Filter
Top Products
7
The Set Up mode is used to configure the general operation of the receiver, to program a
transmitter into the receiver, and to change the characteristics of a programmed transmitter.
The Mode LED does not blink in Set Up mode.
To enter the Set Up mode, press and hold the Mode/Advance switch for approximately two
seconds. You are first prompted to enter a four digit code. "C" is shown on the left of the
display and the digit for each code number is shown on the right of the display. You must enter
one digit at a time. The Set switch is used to increment the value of the digit. The
Mode/Advance switch is used to advance to the next digit of the code. The Mode and Type
LEDs are used to indicate which digit of the code is shown.
When no LED is lit, enter the first digit of the code. When the Type LED is lit, enter the
second digit. When the Mode LED is lit, enter the third digit. When both the Type and Mode
LEDs are lit, enter the fourth digit. The default code is 1111. If the correct code is entered,
you will be allowed to enter Set Up mode. The receiver will return to Run mode if the wrong
code is entered or if the Mode/Advance switch is pressed for two seconds prior to entering all
the digits.
Use the Set switch to increment the first digit of the code.
C 1
Use the Set switch to increment the second digit of the code.
C 1
Use the Set switch to increment the third digit of the code.
C.1
Use the Set switch to increment the fourth digit of the code.
C.1
After entering the code you are prompted to enter the receiver address. "A" is shown on the left
of the display and the current address is shown on the right. The address is changed by
pressing the Set switch. The current address will be stored into memory when the
Mode/Advance switch is pressed. Set Up mode is exited when the Mode/Advance switch is
pressed for two seconds.
NOTE: When using the receiver with an Aegis system, the address must be set to "1".
Next, you are prompted to enter the number of addresses. The letter "n" is shown on the left of
the display and the digit for the current number of addresses is shown on the right of the
display. The number of addresses is changed by pressing the Set switch. The current number
of addresses will be stored into memory when the Mode/Advance switch is pressed. Set Up
mode is exited when the Mode/Advance switch is pressed for two seconds.
NOTE: When using the receiver with an HSP controller, the number of addresses must be set
to "1".