Filter
Top Products
10
If Expansion Enclosures are also being used, set "NUMBER OF EXP ENCL:" to the number of
expansion enclosures plus the number of addresses used by the receiver. Set the addresses for
the expansion enclosures and receiver so that they don't overlap.
After the receiver has been enabled, you can press the down arrow (ò) key to set the zone types
for each of the expanded zones.
CONTROLLER INDICATIONS
When the condition of a transmitter changes state, the HAI controller will display that
condition as follows:
Transmitter Condition Aegis
When a transmitter (zone) is violated Zone Name "NOT RDY"
When a cover is removed from a transmitter Zone Name "NOT RDY"
When a supervisory failure is reported Zone Name "TRBL NOW"
When a battery low is reported Zone Name "HAD TRBL"