Filter
Top Products
6
(not ready) or that have trouble. The transmitter number flashes on the display followed by the
status condition(s).
LED DISPLAY
INFORMATION ABOUT THE LED DISPLAY
1.10
Displays the number of the transmitter with a change in condition.
A L
Displays that the current transmitter is "NOT READY".
C O
Displays that the cover was removed from the current transmitter.
S F
Displays that the current transmitter has a supervision failure.
L O
Displays that the current transmitter has reported a battery low.
NOTE: If the receiver is not communicating with the controller, the Mode LED will blink
four times per second.
SET
- The Set switch is used to increment or change the current selection.
MODE /ADVANCE
- The MODE/Advance switch is used to enter Set Up mode, advance to
the next Set Up item, and to confirm a selection. It is also used to exit Set Up mode.
LED DISPLAY
- The LED DISPLAY is used to show the status of each transmitter and to
ensure proper setup.
MODE LED
- In Run mode, the MODE LED is used to indicate communication status with the
controller. In Set Up mode, the Mode LED is used to give helpful information when entering
your code, and indicates if a transmitter sends a restore code.
TYPE LED
- In Set Up mode, the TYPE LED is used to give information when entering your
code, and indicates if a transmitter is supervised.