Filter
Top Products
QUICK-REFERENCE SETUP GUIDE
To Enter Set Up mode, press and hold the Mode/Advance switch for 2 seconds.
DISPLAY
DESCRIPTION SET SWITCH MODE/ADVANCE SWITCH
C 0
Enter the first digit of the code Increments the digit (0-9) Advances to the next digit
C 0.
Enter the second digit of the code Increments the digit (0-9) Advances to the next digit
C.0
Enter the third digit of the code Increments the digit (0-9) Advances to the next digit
C.0.
Enter the fourth digit of the code Increments the digit (0-9) Advances to the next item
A 1
Enter the receiver address Changes the current address (1-8) Advances to the next item
n 1
Enter number of addresses Changes number of addresses (1-4) Advances to the next item
C 1
Displays the first digit of the code Changes the current digit (0-9) Advances to the next digit
C 1.
Displays the second digit of the code Changes the current digit (0-9) Advances to the next digit
C.1
Displays the third digit of the code Changes the current digit (0-9) Advances to the next digit
C.1.
Displays the fourth digit of the code Changes the current digit (0-9) Advances to the next item
1
Displays the status of transmitter 1 Changes characteristics of transmitter Advances to the next transmitter
2
Displays the status of transmitter 2 Changes characteristics of transmitter Advances to the next transmitter
3
Displays the status of transmitter 3 Changes characteristics of transmitter Advances to the next transmitter
Characteristics of Transmitters:
DISPLAY
MODE LED
TYPE LED
DESCRIPTION OF THE DISPLAY
1
OFF
OFF No transmitter is programmed at this address
1
*
OFF BLINKS This transmitter is not supervised and doesn't send restore transmissions
.1
*
ON BLINKS This transmitter is not supervised but sends restore transmissions
1.
OFF
ON This transmitter is supervised but doesn't send restore transmissions
.1.
ON ON This transmitter is supervised and sends restore transmissions
To reset memory, press and hold the Set and Mode/Advance switches together for 2 seconds.
DISPLAY
DESCRIPTION SET SWITCH MODE/ADVANCE SWITCH
C 0
Enter the first digit of the code Increments the digit (0-9) Advances to the next digit
C 0.
Enter the second digit of the code Increments the digit (0-9) Advances to the next digit
C.0
Enter the third digit of the code Increments the digit (0-9) Advances to the next digit
C.0.
Enter the fourth digit of the code Increments the digit (0-9) Advances to the next item
E E
Erase EEPROM ? (Reset Memory) Press and hold Set & Mode/Advance switches together for 2 seconds