Filter
Top Products
– 46 –
System Programming (cont’d)
Guidelines (continued):
• Pressing Delete when changing a closing time will tell the system that no closing
will occur for that schedule that day (up to midnight). Use this to tell the system
when there is an early morning closing the next day. You must also program a
12:00 AM opening and a closing time (i.e., 3:00 AM) the next day.
• If your schedule is unpredictable, you may need to program a No Close time
period. Upon opening the group, a timer can be preset with a number of hours
and minutes you will be open that day. A closing timer will start when 20
minutes remain. A closing warning will start when only 5 minutes remain. If the
warning and reminder are ignored, and the group is not closed, a No Close signal
will be sent to the ADT Customer Monitoring Center. To program a No Close
time, first select the second schedule for the desired day. Second, delete the
second opening time by pressing Change, Open time, Delete. Third, enter the
number of hours and minutes you will be open on that day as the second closing
time. For example, if you want two hours and 30 minutes, press Change, Close
time, 0, 2, 3, 0, AM. Repeat the procedure for each day that this feature is
desired.
• AM is used for less than 12 hours. If 12 to 24 hours is desired, subtract 12 hours
from the desired length of time, enter the remainder, and press PM. For example,
if you want 14 hours and 20 minutes, press Change, Close time, 0, 2, 2, 0, PM.
• The No Close time will take effect only when the group is opened. If you want the
new time to take effect NOW, first turn on the group and then turn it off.
• The programming of the first schedule for each day is optional. If you do program
the first schedule, openings outside the schedule can be restricted. For example, a
first schedule opening time of 5:00 AM and a first schedule close time of 10:00
PM may restrict certain users from midnight to 5AM and from 10PM to
midnight. Persons who open anytime will be required to close the group in the
specified time period entered in the second close schedule as specified above.
Changing Auto On/Off Schedule
Your FOCUS 200 PLUS security system can accommodate an Auto On/Off
feature. If enabled, the Auto On/Off feature enables your system to
automatically turn itself on and off according to the daily operating schedule
(permanent or temporary) that you have assigned. The Auto On/Off
feature is automatically deleted on holidays and can be cancelled by
deleting a schedule.