Filter
Top Products
– 33 –
System Programming (cont’d)
Once an ID code is assigned to a user, that user may automatically perform
the following functions:
• Turn on/off assigned Burglary Protection.
• Test system sounders.
• Test burglary points.
• View/print the system’s history log.
Each code may also be assigned a specific “Privilege Level(s)” that provides
access to additional system operating functions (see Assigning Privilege
Levels later in this section). If a user does not have the privilege to operate a
function, it will not be displayed as a selection choice.
Note: Upon installation or initial system setup, one user (e.g., System
Manager) will be assigned the “Privilege Level” to perform the following
functions:
• Open outside of the schedules (Irregular open).
• Bypass burglar alarm (BA) protection points.
• Change temporary schedules.
• Change permanent daily schedules and the real-time.
• Change, add, and delete user names, ID codes, card/key codes, cancel
dates, and “Privilege Levels” for users.
Entering or Changing a User Name
Use the following procedure to add new users, change an existing user's
access, or delete existing users from the system.
1. Using the operating panel’s numeric keypad, enter a valid ID code that
has been assigned the privilege level of "Can change names."
2. Press the More button three times to display Action Menu 4.
3. Press ID codes to display the User Selection Menu. Note: If ID codes is
not displayed, you do not have the privilege level of "Can change names."
Consult your manager or ADT Service Representative.