Filter
Top Products
Chapter 2: Prepare the Site
12 X-Series Hardware Installation and Safety Guide V 2.5
Rack and Clearance Requirements
Tipping Point recommends that you mount the TippingPoint X-Series X505 and X506 models in a
standard 19-or 23-inch rack. The vertical hole spacing on the rack rails must meet standard EIA-310-C
requirements, which call for a one inch (2.54 cm) spacing.
Ventilation and Location
Ventilation and proper location are essential to the proper operation of the TippingPoint X-Series
system. Follow these guidelines to ensure that the TippingPoint X-Series receives adequate ventilation,
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top, with the
heaviest component at the bottom of the rack.
• Ensure that the unit is positioned properly on the rack
• There should be a minimum clearance of three inches (7.62 cm) at the ventilation openings.
• When mounting this unit in an enclosed or multi-rack assembly, the operating ambient
temperature of the rack may be greater than that of the room. Ensure that the maximum ambient
temperature of 104° F (40 ° C) is not exceeded.
Environmental Requirements
In order for the TippingPoint X-Series to run properly, your environment must meet the proper
criteria.
The following table lists the recommendations for temperature, humidity, and altitude settings for the
Service Provider (SP) environment.
Reliable Earthing
Ensure the mounting rack is reliably connected to earth.
System Grounding Requirements
Damage from Electromagnetic Static Discharge (ESD) can occur when electronic components are
improperly handled. This damage can result in complete or intermittent system failures. Proper ESD
Table 2 - 1: Environmental Requirements for the TippingPoint X-Series
Environmental
Specifications
Description
Temperature 0 to 40 ° C (32 to 104 ° F) — Operating
-20 to 80° C (-4 to 176 ° F) — Storage
Humidity 5 to 95% (non-condensing)
Altitude No degradation up to 13K feet above sea level