___________________________________________ PC Setup 4-37
• Printing a Calibration Page
• Using the Densitometer
• Linearizing the Densitometer Data
Printing a Calibration Page
To begin calibrating your printer, print a calibration page to measure the
printer’s current performance as a basis for the calibration.
1. Open XANTÉ Command Center and choose Controller:
Linearize. The Linearization window appears (fig. 4.23).
Fig. 4.23 Linearization Window
2. Change the Linearization window LPI setting in the Print box
(fig. 4.23) to achieve 256 levels of gray for the resolution at
which you are printing.
Note: For 600 dpi, select 85 lpi; for 1200 dpi, select 106 lpi;
for 2400 dpi, select 133 to 150 lpi. Any lpi may be
used; measure the lpi that is to be used for final output.
3. Print a Calibration Page to measure the printer’s current
performance as a basis for the calibration. To do this use the
following procedure:
