Print Data *Manual Number Revision
Apr. 2005 SH(NA)030038-C Section 3.3.3: Sentence is added into "POINT".
Section 3.5 (1) (a): Servo on and servo off condition is deleted.
Part of columns of emergency stop and functions/applications
is examined.
Section 3.5 (1) (b): Zero speed Example is added.
Section 3.5 (3): The minimum pulse width of Encoder Z-phase pulse is changed to
400
s.
Section 3.6.2 (1) (a): Note is added.
Section 3.6.3 (1) (a): Note is added.
Section 3.6.3 (3) (a): Note is added.
Section 3.6.4 (3) (a): Note is added.
Section 3.6.4 (3) (b): Content is examined.
Section 3.6.5 (4) (a): Note is added.
Section 3.7 (3): Sentence is examined.
Section 3.8.1: Part of connection diagram is modified.
Section 3.8.2 (4) (b) 2): Part of drawing is modified.
Section 3.8.2 (6): Drawing is examined.
Section 3.10.2 (2) (b): Connector signal allotment CE05-2A32-17PD-B is added.
Section 3.11.1: Sentence is examined.
Section 4.1.2 (1) (c): Examined.
Section 5.1.1: PA16 Initial value is modified to 0.
PA17
PA18 Initial value is modified to 0000h.
PA19 Name is examined.
Section 5.1.4: Parameter No.PA02 setting 01
08 09 are added.
Section 5.1.10: Feedback pulses are changed to droop pulses.
Section 5.2.1: PB14
PB15 PB16 PB18 PB23 are modified to correspond to
speed control mode.
PB44 Initial value is modified to 0.0.
Section 5.2.2: PB02 Sentence is added.
PB07 Setting range is modified to 1~2000.
PB17 Sentence is examined.
PB26 Expression is examined.
Section 5.3.1: PC20 Errors in writing are modified.
Section 5.3.2: PC12 The case of MR-J3-100A to 700A is added.
PC14 Note 2 is added.
PC15 Note 2 is added.
PC17 Sentence is added.
PC22 Sentence is added.
Section 5.3.3 (1): Parameters are separated into each case.
Section 5.3.3 (2): Note 2 is added.
Setting A Horizontal axis is changed to 1Mpulse.
Setting B Horizontal axis is changed to 10Mpulse.
Setting C Horizontal axis is changed to 100Mpulse.
Section 6.6.2 (1) (2): Error in Parameter screen is corrected.
Section 8.1:
Setting of machine resonance suppression filter 2 is modified to
1.
Section 8.6.3 (4): Expression for setting parameter is examined.
Chapter 9: Sentence in "POINT" is changed.
Section 9.1: AL.45
AL.47 Note 1. is added.
Section 9.2: AL.33 Causes 1
2 are added.
AL.46 Modified to thermal sensor.
Section 9.3: Caution is added.
AL.E3 Content is added.
