A SERVICE OF

logo

Open as PDF
next previous
EN
RP, Replot
19-39
RP, Replot
This command is ignored by the printer; to eject a page, the printer
must be in PCL printer language mode. The following commands
cause a conditional page eject; a page is ejected if there is any
printable data in the print buffer:
z
E
C
E
Reset
z
UEL (Universal Exit Language)
z
Flush All Pages
z
Page Length
z
Page Size
z
Orientation
z
Paper Source
The PCL Form Feed control code causes an unconditional page eject
and advances the cursor position to the top of form on the next page.
Note
A page eject caused by any of the above commands except Paper
Source defaults the HP-GL/2 pen position.
To print more than one plot, use the Number of Copies command.
For information about printing more than one copy of an HP-GL/2
illustration, see “Number of Copies Command” in Chapter 4.