EN
Raster Y Offset Command
15-15
Once in Raster Graphics Mode, PCL commands and text imply an
End Raster Graphics (
E
C
*rC
) except for the following commands:
z
Transfer Raster Data
z
Set Raster Compression Method
z
Raster Y Offset
In addition, the following commands are ignored (i.e., locked out)
while in Raster Graphics Mode and do not imply an End Raster
Graphics command:
z
Start Raster Graphics
z
Set Raster Width
z
Set Raster Height
z
Set Raster Presentation Mode
z
Set Raster Graphics Resolution
Notes
An implied End Raster Graphics resets the Raster Compression
Method 3 seed row, but does not reset the Raster Compression
Method nor the left raster graphics margin.
If source and/or transparency modes have been set, frequent
start/end graphics commands in an image can result in a memory
overflow condition.
Raster Y Offset Command
The Raster Y Offset command moves the cursor position vertically
the specified number of raster lines from the current raster position in
the raster area.
E
C
* b # Y
# =Number of raster lines of vertical movement
Default =
N/A
Range =
0 - 32767
This command is recognized only while in raster graphics mode and
only within the raster area.
