show snmp targetaddr Configuring SNMP Target Addresses
Enterasys Matrix DFE-Gold Series Configuration Guide 5-29
Configuring SNMP Target Addresses
Purpose
ToreviewandconfigureSNMPtargetaddresseswhichwillreceiveSNMPnotificationmessages.
AnaddressconfigurationcanbelinkedtooptionalSNMPtransmit,ortarget,parameters(suchas
timeout,retrycount,andUDPport)setwiththesetsnmptargetparamscommand(“setsnmp
targetparams”onpage 5‐27).
Commands
show snmp targetaddr
UsethiscommandtodisplaySNMPtargetaddressinformation.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Parameters
Defaults
•IftargetAddrisnotspecified,entriesforalltargetaddressnameswillbedisplayed.
•Ifnotspecified,entriesofallstoragetypeswillbedisplayedforatargetaddress.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaySNMPtargetaddressinformation:
Matrix(rw)->show snmp targetaddr
Target Address Name = labmachine
Tag List = v2cTrap
IP Address = 10.2.3.116
UDP Port# = 162
Target Mask = 255.255.255.255
Timeout = 1500
For information about... Refer to page...
show snmp targetaddr 5-29
set snmp targetaddr 5-30
clear snmp targetaddr 5-31
targetAddr (Optional)Displaysinformationforaspecifictargetaddressname.
volatile|nonvolatile
|read‐only
(Optional)Whentargetaddressisspecified,displaystargetaddress
informationforaspecificstoragetype.
