A SERVICE OF

logo

Virtual Router Redundancy Protocol Commands 1035
ip vrrp mode
Use the ip vrrp mode command in Interface Configuration mode to enable
the virtual router configured on an interface. Enabling the status field starts a
virtual router. Use the no form of the command to disable the virtual router.
Syntax
ip vrrp
vr-id
mode
no ip vrrp
vr-id
mode
vr-id
— The virtual router identifier. (Range: 1-255)
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the virtual router for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip vrrp 5 mode
ip vrrp preempt
Use the ip vrrp preempt command in Interface Configuration mode to set
the preemption mode value for the virtual router configured on a specified
interface. Use the no form of the command to disable preemption mode.
Syntax
ip vrrp
vr-id
preempt
no ip vrrp
vr-id
preempt