A-3
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Appendix A Supported MIBs
Using FTP to Access the MIB Files
• IEEE8023-LAG-MIB
• IF-MIB (In and out counters for VLANs are not supported.)
• IGMP-MIB
• INET-ADDRESS-MIB
• IPMROUTE-MIB
• OLD-CISCO-CHASSIS-MIB
• OLD-CISCO-FLASH-MIB
• OLD-CISCO-INTERFACES-MIB
• OLD-CISCO-IP-MIB
• OLD-CISCO-SYS-MIB
• OLD-CISCO-TCP-MIB
• OLD-CISCO-TS-MIB
• PIM-MIB
• RFC1213-MIB (Functionality is as per the agent capabilities specified in the
CISCO-RFC1213-CAPABILITY.my.)
• RFC1253-MIB (OSPF-MIB)
• RMON-MIB
• RMON2-MIB
• SNMP-FRAMEWORK-MIB
• SNMP-MPD-MIB
• SNMP-NOTIFICATION-MIB
• SNMP-TARGET-MIB
• SNMPv2-MIB
• TCP-MIB
• UDP-MIB
Note You can also use this URL for a list of supported MIBs for the Cisco ME switch:
ftp://nm-tac.cisco.com/pub/mib_repo/
You can access other information about MIBs and Cisco products on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Using FTP to Access the MIB Files
You can obtain each MIB file by using this procedure:
Step 1 Make sure that your FTP client is in passive mode.
Note Some FTP clients do not support passive mode.
