11-30
Cisco ONS 15310-MA SDH Reference Manual, Release 9.1 and Release 9.2
78-19417-01
Chapter 11 Performance Monitoring
Performance Monitoring for Optical Ports
Figure 11-13 PM Parameter Read Points on the STM16 Ports
Note For PM locations relating to protection switch counts, see the Telcordia GR-1230-CORE document.
The PM parameters for the STM16 ports are listed in Table 11-13. The listed parameters are defined in
Table 11-2 on page 11-4.
ONS 15310-MA SDH-MA
STM16 Port
Pointer Processors
BTC
ASIC
Cross Connect STM-N
RS-EB
RS-ES
RS-SES
MS-EB
MS-ES
MS-SES
MS-UAS
PPJC-Pdet
NPJC-Pdet
PPJC-Pgen
NPJC-Pgen
Path
Level
VC CV-P
VC ES-P
VC
VC SES-P
VC UAS-P
PPJC-PDET
NPJC-PDET
PPJC-PGEN
NPJC-PGEN
PJC-DIFF-P
PJCS-PDET-P
PJCS-PGEN-P
PMs read on BTC ASIC
PMs read on PMC
271813
Table 11-13 STM16 Port PM Parameters
RS (NE) MS (NE/FE)
MS (NE/FE) 1+1
LMSP (NE)
1, 2
1. For information about troubleshooting subnetwork connection protection (SNCP) switch counts, refer to the “Alarm
Troubleshooting” chapter in the Cisco ONS 15310-MA SDH Troubleshooting Guide. For information about creating
circuits that perform a switch, refer to Chapter 7, “Circuits and Tunnels”.
2. MS-SPRing is not supported on the STM-1 card and STM-1E card; therefore, the MS-PSD-W, MS-PSD-S, and
MS-PSD-R PM parameters do not increment.
PJC (NE)
3
3. In CTC, the count fields for the HP-PPJC and HP-NPJC PM parameters appear white and blank unless they are
enabled on the Provisioning > Line tab. See the 11.3 Pointer Justification Count Performance Monitoring section.
VC4 and VC4-Xc
HP Path
(NE/FE4
4
)
5
RS-BBE
RS-EB
RS-ES
RS-SES
MS-BBE
MS-EB
MS-ES
MS-SES
MS-UAS
MS-PSC (1+1)
MS-PSD
HP-PPJC-Pdet
HP-NPJC-Pdet
HP-PPJC-Pgen
HP-NPJC-Pgen
HP-PJCS-Pdet
HP-PJCS-Pgen
HP-PJCDiff
HP-BBE
HP-BBER
HP-EB
HP-ES
HP-ESR
HP-SES
HP-SESR
HP-UAS
