11-19
Cisco ONS 15310-MA SDH Reference Manual, Release 9.1 and Release 9.2
78-19417-01
Chapter 11 Performance Monitoring
Performance Monitoring for Ethernet Cards
11.6 Performance Monitoring for Ethernet Cards
The following sections define PM parameters and definitions for the CE-100T-8, CE-MR-6, and
ML-100T-8 Ethernet cards.
11.6.1 CE-100T-8, CE-MR-6, ML-100T-8 Card Ethernet Performance Monitoring
Parameters
CTC provides Ethernet performance information, including line-level parameters, port bandwidth
consumption, and historical Ethernet statistics. The CE-100T-8, CE-MR-6, and ML-100T-8 card
Ethernet performance information is divided into Ether Ports and POS Ports tabbed windows within the
card view Performance tab window.
11.6.1.1 CE-100T-8, CE-MR-6, and ML-100T-8 Card Ether Ports Statistics Window
The Ether Ports statistics window lists Ethernet parameters at the line level. The Ether Ports Statistics
window provides buttons to change the statistical values shown. The Baseline button resets the displayed
statistics values to zero. The Refresh button manually refreshes statistics. Auto-Refresh sets a time
interval at which automatic refresh occurs. The window also has a Clear button. The Clear button sets
the values on the card to zero, but does not reset the CE-100T-8, and ML-100T-8 cards.
During each automatic cycle, whether auto-refreshed or manually refreshed (using the Refresh button),
statistics are added cumulatively and are not immediately adjusted to equal total received packets until
testing ends. To see the final PM count totals, allow a few moments for the PM window statistics to finish
testing and update fully. PM counts are also listed in the CE-100T-8 and ML-100T-8 card Performance >
History window.
Table 11-6 defines the CE-100T-8, CE-MR-6, and ML-100T-8 card Ether Ports statistics parameters.
Table 11-5 DS3 Port PMs
Line (NE) Path (NE)
1, 2
1. C-Bit and M23 framing path PM parameters
2. The C-bit PMs (PMs that contain the text “CP-P”) are applicable only if line format is C-bit.
Path (FE)
1, 2
VC3 Low-End Path (NE/FE) VC4 HP Path (NE/FE)
MS-EB
MS-ES
MS-SES
LOSS-L
AISS-P
CVP-P
ESP-P
SASP-P
3
SESP-P
UASP-P
CVCP-P
ESCP-P
SASP-P
SESCP-P
UASCP-P
3. DS3 ports support SAS-P only on the Rx path.
CVCP-PFE
ESCP-PFE
SASCP-PFE
SESCP-PFE
UASCP-PFE
LP-BBE
LP-BBER
LP-EB
LP-ES
LP-ESR
LP-SES
LP-SESR
LP-UAS
HP-BBE
HP-BBER
HP-EB
HP-ES
HP-ESR
HP-SES
HP-SESR
HP-UAS
