9
Included with Your Scanner
・ Owner’s Manual
・ Scanner and Antenna
・ Belt Clip (with 2 screws)
・ Adapter
・ Battery set ( 2 pcs NiMH )
Note: If any of these items are missing or damaged, contact
your place of purchase.
Setting Up Your Scanner
These guidelines will help you install and use your new scanner:
• If your scanner receives interference or electrical noise,
move the scanner or its antenna away from the
source.
• To improve the scanner’s reception, use an optional
external antenna designed for multiband coverage.
(You can purchase this type of antenna at a local
electronics store). If the optional antenna has no cable,
use 50 Ohm coaxial cable for lead-in. A mating plug
might be necessary for the optional antennas.
• Use an optional mono earphone or mono headset with
proper impedance for private listening. Read the
precautions on the inside front cover of this Owners
Manual.
• Do not use the scanner in high-moisture environments
such as the kitchen or bathroom.
• Avoid placing the scanner in direct sunlight or near
heating elements or vents.
Using Internal Batteries
You can power your scanner using the supplied rechargeable
NiMH batteries ( 2 x AA).
Using Rechargeable Batteries
Before you use NiMH or NiCd batteries the first time, you must
charge them. It may happen, that the first battery charging may
not reach the full capacity, but the final capacity will be ok after at
least 2-3 times charging.
The scanner has a built-in circuit that lets you recharge NiMH or
NiCd batteries while they are in the scanner.
To charge the batteries;
1. Make sure the power is turned off.
2. Slide the battery compartment cover.
3. Install two batteries in the compartment as indicated by the
polarity symbols (+ and -) marked inside.
