21
• Press Func + Pgm in chain search mode or chain search
hold mode. The lowest blank channel and bank appear.
• Press E / Pgm to store the frequency into the blank
channel. To select another channel, press Func +
or Func + before you press E / Pgm. You can also
press 0-9 to select the bank.
If you try to save a frequency that is already stored, the
scanner sounds an error tone and displays the channel that
was duplicated.
• If you entered the frequency by mistake, press ●/Clr.
• To enter the frequency anyway, press E to accept.
The scanner sets itself to program mode after you store a
frequency.
Setting the Search Range
You can use this mode to define the search range used during
a search in each search bank.
• To change a search range, press Func and PSrc. In the
display SRCH appears.
• Then select a search bank. When you select the search
bank, the lower limit and upper limit frequency assigned
in the search bank alternate on the display.
• To select another search bank, press Func + PSrc or
Func + to increase the search bank number or Func
+ to decrease it.
• Hold down Func + or Func + for about 1 second
to quickly move through the search bank numbers.
After choosing the search bank, follow these steps to set the
lower limit and upper limit frequency.
• Enter the lower limit frequency by using the 0-9 and ●
/Clr keys.
• Press E to select the lower limit frequency.
• Enter the upper limit frequency by using the 0-9 and ●
/Clr keys.
• Press E to select the upper limit frequency.
Direct Entry Search
You can use direct entry search to search up or down from the
currently displayed frequency.
• If the scanner is scanning or searching, press Hold.
• Enter the frequency you want to start from by using the
number keys 0-9. (Use ●/Clr to enter a decimal point).
