22
• Press Func + or Func + . The scanner searches,
starting from the frequency you entered in the step
before.
• If you enter a frequency that is out of range, the scanner
sounds an error tone and Error appears.
• Press Func + to change the search direction
downward or Func + to change the search direction
upward. Frequencies appear during the search.
Notes:
• You can set the delay function on or off during the search
or while the search stops.
• You can skip a frequency when the search stops. After
the search skip frequency is set, the scanner starts direct
search again.
Direct Entry Search Hold Mode
• To stop searching during direct entry search, press Hold.
Hold appears.
• In this mode, pressing Func + changes the search
direction downward and pressing Func + changes
the search direction upward.
• or appears depending on the search direction.
• Press Func + to decrease the frequency by one step
or Func + to increase it by one step.
• Hold down or for about 1 second to quickly increase
or decrease the frequency.
• To resume direct search, press Func + Src or Hold.
or appears on the display, showing the search
direction.
Storing Frequencies found during Direct Entry Search
into Channel Memory
Follow these steps to store frequencies received during direct
entry search mode or direct entry search hold mode.
• Press Func + Pgm in direct entry search mode or direct
entry search hold mode. The frequency and lowest blank
channel alternate on the display.
• Press E / Pgm to store the frequency into the blank
channel. To select another channel, repeatedly press
Func + or Func + to select the blank channel you
want, then press E / Pgm. You can also use the 0-9 keys
to select the bank.
If you enter a frequency that has already been entered
elsewhere, the scanner sounds an error tone and displays the
channel that was duplicated.
