18
• When you enter a frequency into a channel, the
scanner automatically turns on the delay function and
DLY appears. When delay is turned on, the scanner
automatically pauses scanning
• 2 seconds after the end of a transmission before
scanning proceeds to the next channel. To turn the
function off or on, press Func + Dly.
• If you enter a frequency that has already been entered
elsewhere, the scanner sounds an error tone and
displays the channel that was duplicated. If you
entered the frequency by mistake, press Clr then enter
the correct frequency. To enter the frequency anyway,
press E to accept.
• To program the next channel in sequence, press
E / Pgm and repeat Steps 2) and 3).
Searching for active Frequencies
If you do not have a reference to frequencies in your area, use
a search to find a transmission.
Note: When the scanner starts searching, it automatically
turns on the delay function. To turn delay on or off, press
Func + Dly.
Service Search
You can search for aircraft and FM CB transmissions without
knowing the specific frequencies used in your area. The
scanner is preprogrammed with all the frequencies allocated
to these services. To use this feature, press Func + Svc.
SRCH appears and the scanner searches starting with the
aircraft service bank. To select a different service bank,
repeatedly press Func + Svc. Service mode appears on the
display. When the scanner stops on a transmission, press
Hold to stop searching and listen to the transmission. Hold
appears. In this mode, you can press Func + or Func
+ to step through the frequencies.
To release the hold and continue searching, press Hold. Or, if
you did not press Hold, simply press Func + or Func +
to continue searching.
Storing Frequencies into Channels During Service Search
You can store frequencies you found during service search or
service search hold mode into channels.
• Press Func and Pgm during service search or service
search hold mode. The frequency and the lowest blank
channel alternately appear.
• Press E / Pgm to store the frequency into the blank
channel. If you want to select another channel, press
Func + or Func + before you press E/ Pgm. You
can also use the 0-9 key to select the bank.
If you entered a frequency that has already been entered
elsewhere, the scanner sounds an error tone and displays the
channel that was duplicated. If you entered the frequency by
