20
10 Search Bands Band Plan 2
Frequency Range MHz Steps
1 25.0000 - 84.0100 5 kHz
2 84.0150 - 87.2550 20 kHz
3 old 108.0000 - 136.9875 12.5 kHz
3 new 108.0000 - 136.9916 8.33 kHz
4 137.0000 - 143.9950 5 kHz
5 144.0000 - 145.9875 12.5 kHz
6 146.0000 - 173.9900 10, 12.5 kHz
7 406.0000 - 449.99375 6.25 kHz
8 450.0000 - 469.9900 10 kHz
9 470.0000 - 512.0000 6.25 kHz
10 806.0000 - 960.0000 12.5 kHz
To switch the band plan between 1 and 2:
• Make sure the power is turned off.
• While holding down 0, turn on the scanner.
Note: Please carry out a memory initialization (Reset) after
band plan was changed. We recommend to change the band
plan setting immediately for the correct country setting before
first use of the scanner, later, in most cases, changing will be
no more necessary.
Chain Search Mode
Press Func + Src to start chain search mode. SRCH, the
enabled search bank number, and or (indicating the search
direction) appear. The search bank number being searched
flashes.
Press 0-9 to enable or disable the search bank number being
searched in this mode. Enabled bank numbers appear.
(Disabled bank numbers disappear).
At least one search bank must be enabled. (The scanner
sounds an error tone if you try to disable all the search banks).
The search bank and the frequency where chain search starts
depends on how the scanner was set before you selected
chain search mode.
Chain Search Hold Mode
To start chain search hold mode, press Hold in chain search
mode. The scanner stops searching and HOLD appears.
• In this mode, pressing Func + changes the search
direction downward and pressing Func +
changes the search direction upward.
• or appears according to the current search
direction.
Storing Frequencies Found During Chain Search into
Channel Memory
You can store frequencies you find in chain search mode or
chain search hold mode.
