Filter
Top Products
EYEBOLT
NUT
FLAT WASHER
CAGE NUT
CHAIN
CASE TOP
POWERED EXHAUST FAN
1 FT. CLEARANCE
(BACK OF HEATER TO WALL)
ENTRY/EXIT
SHUTTERED AIR
INLET
CHAIN/CABLE
SEDIMENT TRAP
GAS HOSE
MANUAL SHUTOFF VALVE
SECOND STAGE
REGULATOR
(VENT POINTED DOWN)
GAS SUPPLY LINE
HEATER
(SUPPORTED BY
METAL FRAME
OF GREENHOUSE)
AIR FLOW
FIG. 3
9
This heater may be mounted within the greenhouse for
indoor heating applications. The heater may be installed on
an optional indoor mounting bracket kit, part number
23651, which is installed on freestanding supports or
mounted directly to the structure’s wall. Separate
installation instructions accompany the kit.
The heater may also be suspended by chain to the
greenhouse’s overhead structure by using an optional chain
hanging kit, part number 08748. Refer to the following
instructions and illustrations.
1. Assemble eyebolts and chain according to the
illustration and tighten all eyebolts securely.
See Fig. 2.
FIG. 2
2. Be sure heater is securely fastened to overhead
supports and is hanging level. (Check crosswise and
lengthwise.)
3. See Fig. 3 for
typical
indoor installation. In any
installation, consideration must be given to making
sure the heater is located away from the people
entering or exiting the greenhouse so they cannot
accidentally knock the heater or tamper with the
heater and its gas supply line in any way. Additionally,
the heater must be located so that it does not block
the normal entryway or exit of the building. Make
sure you observe and obey minimum clearance
distances to combustible materials as stated in the
specification section of this owner’s manual and on
the heater’s dataplate.
INDOOR INSTALLATION INSTRUCTIONS