Filter
Top Products
Second section 1/8”
Inside lock
End cap
(4) 1/4”-20 x 11/16”
Self drilling screws
Square hole in
vertical track
Pull Down Rope
Tools: Power drill, 1/8” Drill bit, Tape measure
WARNING WARNING
DO NOT INSTALL PULL DOWN ROPE ON DOORS WITH OPERATORS. CHILDREN
MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR FATAL INJURY.
Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the
right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the
no. 6 screw eye and to the bottom corner bracket, as shown.
Bottom corner
bracket
Pull down
rope
No. 6 Screw eye
Pull down
rope
48” to 50”
From floor
Step Plate
Tools: Tape measure, Power drill, 7/16” Drill bit, 7/16” Wrench, Phillips
head screwdriver
Make one mark 1” (25 mm) up from the center of bottom edge of the bottom section and
another mark 2-3/16” (56 mm) up from the first mark.
NOTE: Top of step plate can be no higher than 8” from the bottom of the door.
Drill a 7/16” (11 mm) hole through the section at each mark and insert the outside step plate.
Loosely fasten step plate slide to base with (1) 1/4”-20 x 5/8” carriage bolt and nut. Align inside
step plate holes and fasten from inside using the #8 screws provided. Install one #8 x 3/4”
screw in the bottom step plate hole. The screw in the top hole varies with door models. Use the
screw size shown below for your model door.
a) #8 x 3/4” screw for model 9100
b) #8 x 1” screw model 9400/9600
Tighten 1/4”-20 carriage bolt and nut.
Outside step plate
2-3/16”
1”
Bottom
section
Hex nut
1/4” - 20 x 5/8”
Carriage bolt
Step plate
base
Step plate
slide
Assembled inside step plate
#8 screw
Bottom
Section
Strut
14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,
refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com