Filter
Top Products
8
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Pull handle placement reference on double wide doors
2
Tape Measure
Pencil
Power Drill
1/16” Drill Bit
Pull Handle Installation
Bottom section
Locate the
center
(2) #10 X 5/8” Pan
head self tapping
screws
Pull handle
Bottom section
Pull handle placement reference on single wide doors
NOTE: For door section identification see page 4.
Locate and mark the horizontal and vertical center
on the bottom rail of the bottom section, on single
car doors.
Center the pull handle using the vertical and
horizontal lines as reference on the bottom section
rail as shown. Using the pull handle as a template,
mark the two holes in the pull handle on the
horizontal line of the bottom section rail. Drill a 1/16”
pilot hole, then fasten pull handles using (2) #10 X
5/8” pan head self tapping screws.
If the door came with two pull handles, locate them
directly below the lift handles and repeat installation
process.
Use reference illustrations below for lift handles
positions on singles and double car garage doors.
20” Min. To
30” max.
20” Min. To 30” max.
6” Max.