Filter
Top Products
What you need to do:
insert batteries, test and install
1. Open the battery cover (5). Insert
supplied 9V
battery by connecting the battery contacts and
close the battery cover.
2. Press the test button (2). LED light
on detector (1) will illuminate, as will green
doorbell LED icon on remote, which will also
vibrate. A beep alert will sound in your
hearing instruments. Press acknowledge
button on the remote to stop alerts. (If this
does not work as described, please see
troubleshooting section).
3. To install, position on wall or door
so that “red triangle” is no more than 1.5 in/
3 cm from doorbell’s chime box. Use either
supplied screws to suspend from key hole (7),
or self-adhesive velcro tape (see illustrations
A – C this page). If tape is used, the wall
on which detector is to be positioned can be
cleaned using supplied wet wipe for best
adherence.
TIP
Your doorbell detector should
be able to detect most doorbells,
including electromechanical ones
and intercom phones, provided
they emit a clear tone without any
significant and rapid variations in
sound.
Max 3cm
A
B
C
or