Filter
Top Products
3
Access Codes
Access codes are used to arm and disarm the system. There are 37 access codes available: 1 master
code, 32 regular access codes, 2 duress codes and 2 supervision codes. Ask your installer for more
information on using the duress and supervision codes.
Only the Master Code can be used to program additional security codes and to change other system
features as well as to arm and disarm the security system. The Master Code will be supplied to you by your
installer. All keypad entries are made by pressing one key at a time.
All access codes can be programmed by following the procedure outlined in “Programming Security
Codes” on page 6.
NOTE: An access code can be a four or six digit number depending on how your installer has
programmed your system. Ask your installer for more information regarding access codes.
Arming the System
Arming Procedure:
In an attempt to reduce false alarms, your system is designed to notify you of an improper exit when
arming the system. With the Push to Set or the Final Door Set, if you enter your code to arm the system
your panel will start an infinite exit delay. The keypad will sound a beep once ever second. If you violate a
zone while exiting the premise the keypad will sound 6 quick beeps when you walk past a motion
detector or open a window or door with a magnetic contact on it. When you have opened and closed the
Final Exit door or after closing the final exit door have pressed the Push to Set button, the keypad will
continue to beep once every second for 5 seconds. The panel uses these 5 seconds to allow time for the
detectors on the system to settle back to their normal states. At the end of this settling time the system
checks for detectors/windows/doors that may be open. If any of these are open the panel will sound a
tone and arming will be canceled. If this occurs, you must re-enter the premises, check the system,
close any open zones, and the follow the arming procedure again.
Arming from an LED Keypad:
If the Ready light is ON, the system is ready for arming. If the Ready light is OFF, check to see that all doors and
windows are closed and that motion is stopped in areas covered by motion detectors. The system cannot be
armed unless the Ready light is ON indicating that all zones are closed and the system is in the Ready state.
Enter your access code. As each digit is entered, the keypad sounder will beep. If the access code was entered
incorrectly, the keypad buzzer will sound steadily for one second. If this occurs, press the [#] key and re-enter
your access code. If the correct access code is entered, the keypad sounder will beep quickly and the Armed
light will come ON. Exit the premises through the door indicated by your installer as the Exit/Entry door.
The panel will provide an exit delay period, indicated by keypad beeps, for you to exit the premises without
causing an alarm. At the end of the exit delay period, all keypad lights, except the Armed light, will turn OFF and
the system will be armed. You can restart the exit delay once by pressing the Away button before the exit delay
expires. The exit delay time can be changed by your installer.
Arming from an LCD Keypad:
If the Ready light is ON, the system is ready for arming. If the Ready light is OFF, this
message will appear on the LCD display. Ensure all doors and windows are closed
and motion is stopped in areas covered by motion detectors. The system cannot be
armed unless the Ready light is ON indicating that all zones are closed and the system
is in the Ready state.
When this message appears, use the arrow (< >) keys to verify that the system is clear
of troubles and that no zones are bypassed unintentionally (see “Viewing Trouble
Conditions” on page 11, and “Zone Bypassing” on page 10).
Secure System
Before Arming <>
Enter Code to
Arm System <>