Filter
Top Products
11
Additional Zone Bypassing Features
To recall the last set of bypassed zones, press [✱][1][9][9]. Arm the system. The Bypass light will turn on
to indicate that zones are bypassed.
To clear all bypassed zones, press [✱][1][0][0].
Viewing Trouble Conditions
The control panel continuously monitors a number of possible trouble conditions. If one of these trouble
conditions occur, the keypad will beep twice every 10 seconds until you press any key on the keypad.
NOTE: A TROUBLE condition reduces the security your system is designed to provide. Call your
installing company for service.
To view troubles from an LED Keypad:
A trouble will be indicated by the Trouble light (or System light on a PC1555RKZ keypad) which will
remain ON until the trouble condition is cleared. If you cannot determine the cause of the trouble
condition, contact your installer for assistance.
To view the type of trouble condition, press [✱][2]. One or more zone lights will turn ON, indicating the
various trouble conditions:
ZONE LIGHT TYPE OF TROUBLE
1 ................. Service required. Call your installation company for service.
2 ................. Indicates the loss of AC power. When this trouble occurs, the Trouble (or System) light
will turn ON but keypad buzzer will not sound.
3 ................. Telephone line trouble.
4 ................. The panel has failed to communicate with the central station.
5 ................. Zone fault. Press [5] and the zone light(s) corresponding to the faulted zones will turn ON.
6 ................. Zone tamper. Press [6] and the zone light(s) corresponding to the tampered zones will
turn ON.
7 ................. Low zone battery. This trouble is generated when a wireless device exhibits a low
battery condition.
Press [7] one, two, or three times to view which devices are experiencing battery
failure. The following will occur:
Keypad beeps: Keypad displays:
Press [7] 1 Zones with low batteries (LED keypad - zone lights 1 to 8)
Press [7] again 2 Handheld keypads with low batteries (LED keypad - zone lights
1 to 4)
Press [7] again 3 Wireless keys with low batteries (LED keypad - zone lights 1 to
8).
To view the battery conditions of wireless keys 9 through 16,
you must be at an LCD keypad.
8 ................. Loss of time on system clock. To set the system time, following the instructions in
“Setting System Date and Time”.