Filter
Top Products
– 140 –
6. How to replace the sensor (Continued)
No.
4
Work procedure
7. How to clean the drain port
No.
1
Work procedure
As same as the work procedure of the sensor
replacing, remove the right side plates and the
shielding plate, and then carry on the work.
Explanatory drawing
Insert the connectors into the specified positions on P.C. board.
Check carefully the directions on P.C. board so that wrong insertion is not done.
• TA sensor : CN104 (Yellow)
• TC sensor : CN101 (Black)
• TCJ sensor : CN102 (Red)
Explanatory drawing
CN102
Red
White
CN101
CN104