Filter
Top Products
– 87 –
No.
i
Part name
Compressor
Procedure
1) Evacuate refrigerant gas.
2) Perform works of items 1 of c, 1 of d, e
and f.
3) Remove screws which fixes the piping panel
(Front) and the bottom plate.
(M4 (Hexagon) x 10, 2 pcs.)
4) Remove screw of the piping panel (Front)
and the piping panel (Rear).
(M4 (Hexagon) x 10, 1 pc.)
5) Remove screws fixing the partition plate to
the valve support plate.(M4 x 8, 2 pcs.)
6) Remove the valve support plate.
(M6 x 4 pcs.)
7) Remove screws of the partition plate and the
bottom plate. (M4 x 8, 1 pc.)
8) Remove screws of the partition plate and the
heat exchanger (M4 x 8, 2 pcs.)
9) Remove the noise-insulator.
10) Remove the terminal covers of the com-
pressor, and disconnect lead wires of the
compressor and the compressor thermo
assembly from the terminal.
11) Remove pipes connected to the compres-
sor with a burner.
CAUTION
Pay attention to that flame does not involve 4-
way valve or PMV.
(If doing so, a malfunction may be caused.)
12) Pull the refrigerating cycle upward.
13) Remove bolt fixing the compressor on the
bottom plate. (3 pcs.)
14) Pull the compressor toward you.
CAUTION
When reconnecting the lead wires to the
compressor terminals after replacement of the
compressor, be sure to caulk the Faston
terminal without loosening.
Remarks
Partition plate
Valve support plate
Screw
Valve
support
plate
Compressor
lead wire
Case thermo
Valve
Piping panel
(Front)
Piping panel
(Front)
Valve support
plate
Partition plate
Remove (Suction pipe)
Sensor pipe cover
Case thermo
Remove
(Discharge pipe)
Compressor bolt (3 pcs.)
Case thermo
Remove
(Discharge pipe)