Filter
Top Products
– 86 –
No.
h
Part name
Fan motor
Procedure
1) Perform works of items 1 of c, 1 of d,
2) Remove the flange nut fixing the fan motor
and the propeller fan.
• Loosen the flange nut by turning clock-
wise. (To tighten the flange nut, turn it
counterclockwise.)
3) Remove the propeller fan.
4) Remove the lead wire from the hook fixing
the fan motor lead wires on the motor
base. (Three positions)
5) Disconnect the connector for fan motor
from the inverter.
6) Remove the fixing screws (4 pcs.) while
holding by hands so that the fan motor
does not fall.
*(Note)
• Tighten the flange nut with torque 4.9N•m
(50kgf/cm).
• Be careful that the reactor does not come
to contact with the fan motor lead at the
rear side of the inverter assembly.
CAUTION
Using a bundling band on the market, be sure
to fix the fan motor lead wire to the motor
base so that it does not come to contact with
the propeller fan.
Remarks
Flange nut
Flange nut
Loosened by
Loosened by
turning clockwise
turning clockwise
Fan motor
Fan motor
Motor base
Fix with
bundling
band
Loosened by
turning clockwise
Flange nut
Fan motor