Filter
Top Products
Starting the Standalone Demos
Running the Demonstration Software 3-3
❏ Command line. Once you have connected the EVM to a workstation
and installed the necessary software (as described in Section 4.3.1,
Installing the Target Linux Software), you can run the demos from the
board’s Linux command line. For further information on running the
demos from the command line, see the demo documentation that is
linked to by the DVSDK release notes.
Note: When you run the demos from the command line, make sure
the interface process used by the standalone mode demos is not
running. Otherwise you will see error messages raised when device
drivers fail to open.