Filter
Top Products
Setting Up the Hardware
EVM Hardware Setup 2-3
1) On the S3 mini-dip switch, verify that positions 1 through 4 are
configured to boot from on-board NAND as in the following figure,
where the black rectangle is the switch location.
Also on the S3 mini-dip switch, verify that position 10 selects the
correct video format—NTSC or PAL. The following diagram shows
the switch in the NTSC setting.
2) Connect an audio speaker to Stereo Line Out (P5) and an audio
source to Stereo Line In (P3).
1
2
3
4
5
6
7
8
9
10
Audio In (P3) Audio Out (P5)