Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE.
6
Note: Framing dimensions in Figures 4 - 9 are calculated for a nailing flange depth of
¹⁄₂
" (13 mm).
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Step 3. Remove the nailing flanges from the
lower control compartment and install in place
with three (3) screws each. Align with the
three holes on each side of the appliance (see
Figure 11
).
Figure 11
All units come complete from the factory with
an installed hood. Ensure that the hood is
installed. If required, position the hood in the
open area above the appliance door covering
the diverter baffles. Insert the tabs, on each end
of the hood, into the bracket at each end. Bend
the two tabs over to secure.
Step 4. Position appliance into prepared fram-
ing, secure with 6d nails at the nailing flange
along each side.
Step 5. Connecting Gas Line – Make gas line
connections. All codes require a shut-off valve
mounted in the supply line.
Figure 12
illus-
trates two methods for connecting the gas
supply. Installation methods and materials
must be in compliance with local codes.
The header may be in direct contact with the top
metal spacers, but must not rest on them or be
notched to fit around them.
Step 2. Route a ¹⁄₂" (13 mm) gas line along the
left or right side framing (
see Figure 10
).
Nailing Flange
All appliances have a 3" long ³⁄₈" NPT nipple
installed at the valve. To quickly and easily
complete the gas line routing, use the gas flex
line kit, Model GFLV.
37" (940mm)
15¹⁄₂"
(394mm)
Outside Wall
CF5500
Back Wall of
Chase/Enclosure
Including Finishing
Materials If Any.
37" (940mm)
58 ¹₂" (1473mm)
13 ¹₂"
(343mm)
29"
(737mm)
41"
(1041mm)
CF5500
Back Wall of
Chase/Enclosure
Including Finishing
Materials If Any.
37 ¹⁄₄"
(946 mm)
37"
(940 mm)
15 ¹⁄₂"
(394 mm)
CF5500
Back Wall of
Chase/Enclosure
Including Finishing
Materials If Any.
41" (1041mm)
19 ¹⁄₂"
(495mm)
Outside Wall
CF6500
41" (1041mm)
67 ³₄" (1721mm)
14 ¹₄"
(362mm)
33 ⁷₈"
(860mm)
47 ⁷₈"
(1216mm)
Back Wall of
Chase/Enclosure
Including Finishing
Materials If Any.
CF6500
42 ³⁄₈"
(1076 mm)
41"
(1041 mm)
19 ¹⁄₂"
(495 mm)
CF6500
3"
(76 mm)
CF6500 - 8¹⁄₂"
(216 mm)
CF5500 - 7¹⁄₂"
(191 mm)