Filter
Top Products
It is recommended that the dryer be Self-Optimized. The following steps should be taken to self
optimize the dryer:
a.) Press and hold the “EXIT” button for at least 2 seconds.
b.) “tunE” will flash while self-optimization is in progress (can take several minutes)
c.) When “tunE” stops flashing; self-optimization is completed.
d.) When self-optimization is complete press “EXIT” key once.
e.) At this point the dryer is ready to run continuously.
Note: If for any reason the “FAULT” orange light goes on, please go to
Chapter-4 in this operation manual for troubleshooting
instructions.
(CAUTION: DO NOT TURN MAIN POWER DISCONNECT TO
THE OFF POSITION WITHOUT FIRST TURNING
THE BLOWER SWITCH TO THE OFF “0”
POSITION. WAIT UNTIL THE BLOWER HAS
TIMED OUT PRIOR TO DISCONNECTING MAIN
POWER.)