STT40 / STT70
Start up 3-1
3. Start up
This chapter is addressed to the operators of the machine.
It assumes the operator has general skills with drying equipment
and that the functional description has been read and
understood.
Ensure that the operators have the required experience.
) Make sure that the main switch is set to the “0" position.
Check the drying hopper for cleanliness.
Check to see whether the adhesive film on the drying hopper has
been removed.
If there is a return air cooler, switch on the coolant circuit.
If there is a timer clock (optional), adjust it. Read the timer clock
operating manual.
Check whether the release switches for the “Timer” and the
“Hopper” (ST1, ST2) are set to the ”0" position.
The “trouble” signal lamp may flash shortly while the valve block
is being changed.