Filter
Top Products
(User ID Number 12)
(ADD)
(ENTER)
Add a Transponder (Key Tag or Card) to the System:
Put the unit into the Program mode (See Page 8). Press
ADD, then press the sequence of digits representing the
desired User ID Number (1-100), then press ENTER. Hold the
Transponder near the Unit. A green light and beep means that
the Transponder was accepted. For example, to program a
transponder into User ID Number 12, the following sequence
would be followed;
+ 1 + 2 + (Hold Key Tag or
Card near unit)
Record the User ID Number and Transponder ID Number.
NOTE: If you assign a new transponder to a User ID Number where
another transponder was already assigned, the new transponder
will replace the old transponder for that User ID Number.
NOTE: Adding the Same Transponder More Than Once
If you add the same Transponder to the system more than
once, the Transponder ID will be deleted from the previous
User ID Number position and added to the newest User ID
Number position.
Radio Key
®
RK-65K Operating Guide
Secura Key 23