Filter
Top Products
5(E)
Using the RM Configuration menu under the
Maintenance menu, the function of this button can be
changed to switch only between FULL and LOCK
modes
(see page 19(E)).
The RM Configuration menu operation is possible in
any mode.
4 STANDARD button
When you press this button, the video camera is
initialized to its standard state, and the button lights for
several seconds.
If you press the button while lit, the video camera
retrieves the state before the button was lit.
5 Spare button
For future use.
6 Test signal output select buttons
Press and light up one of these buttons to activate the
test signal generator of the video camera and send the
respective signals.
TEST: To send a signal to test the video circuits.
You can select the kind of the test signal to be
output using the RM Configuration menu under the
Maintenance menu
(see page 19(E)).
BARS: To send a color bar signal
Note
The BARS button takes priority to the TEST button. If
the BARS button is lit, press the button to turn it dark
before pressing the TEST button.
7 CLOSE button
Press and light the button to close the iris. To release
the close mode, press the button again so that it goes
dark.
8 VTR START/STOP button
Press and light up this button to start a recording
operation. When you press the button when lit, it goes
dark, and recording stops.
Using the RM Configuration menu under the
Maintenance menu, you can assign the CALL button
function to this button
(see page 19(E)). In this case,
press to send a call signal to the video camera, on
which the CALL button lights. The tally lamps on the
camera and the red tally lamp on the camera control
unit light when not lit, or go dark when lit.
When the CALL button on the video camera is
pressed, the button on this unit lights and a buzzer
sounds.
9 VTR playback control buttons
Controls VTR playback operations.
s (stop) button
Press to stop a rewind, fast-forward or playback
operation.
j (rewind) button
Press and light this button to start a rewind operation.
G (play) button
Press and light this button to start a playback
operation.
J (fast forward) button
Press and light this button to start a fast-forward
operation.
7 (recording review) button
Press and light this button to execute a recording
review operation.
Notes
• When the VTR START/STOP button is lit, these
buttons are deactivated. To activate the buttons, first
press the VTR START/STOP button to cancel
Recording mode.
• A part of the VTR control functions of this unit may
be disabled depending on the combination of camera
and VTR. For details, ask your Sony dealer.
0 ALARM indicator
Flashes or lights in red when trouble occurs in the
camera system and the self-diagnostic function
activates at the video camera or the camera control
unit.