Filter
Top Products
Viewing Product Information
Boiler Selection
The Boiler Selection screen is divided into four panes. The top pane allows you to enter load requirements
(Btu/hr) and the type of fuel to be used. The second pane starts off blank but then requests additional
information based on the fuel type you selected. The third pane identifies the boilers that meet your
requirements, and the fourth panel allows you to select a boiler, cancel, or generate a proposal.
Boiler Selection Screen
Pane #1: Enter load and fuel
type requirements.
Pane #2: Prompts for
additional data based on fuel
type selected. Also, allows
you to view product sheets.
Pane #3: Identifies boilers that
meet requirements.
Pane #4: Click OK to accept,
Cancel to close screen, or
Proposal to generate a
proposal.
1. Make certain that a value has been entered into the Btu/Hr Load box in pane #1. If there is no value,
review section Heat Load is Known or Calculated Heat Load, above.
2. In Fuel Type, click on the down-arrow. A pull-down menu is displayed showing the fuel type choices
(natural or propane gas, oil, dual fuel, or electric). Select a fuel type. Depending on the fuel type you
select, pane #2 may request additional information, as shown below.
Note: As you make selections in the Boiler Selection Screen, buttons will be displayed in pane #2
allowing you to access relevant product data. You may click on any of these buttons to review the
data.
26 Slant/Fin Corporation