Filter
Top Products
34
D. THREADING THE NEEDLE EYE
DRAWING UP THE BOBBIN THREAD
This machine can start to sew without drawing up
the bobbin thread If you want to start sewing with
longer bobbin thread, draw up the bobbin thread
as follows.
1. Insert the bobbin into the bobbin holder as
shown on page 30, but do not cut thread.
2. Raise the presser foot.
3. Hold thread loosely and press needle up-down
button twice from up position. The hand wheel
will turn one complete revolution.
4. Pull upper thread lightly. Bobbin thread will
come up in a loop.
5. Pull both upper and bobbin threads about 10
cm toward the back of presser foot.
6. Replace the bobbin cover. (See page 30)
CAUTION: To prevent accidents.
1. Keep fi ngers away from all moving parts.
Special care is required around the needle.
2. Do not lower the threader lever while machine
is operating.
Note:
The needle threader is used for needle sizes
11/80, 14/90, and 16/100.
1. Lower the presser foot.
2. Check that the needle is raised to its highest
position. If it is not, raise needle by pressing
needle up/down button.
3. Lower the threader slowly and draw thread
through thread guide (a) and pull toward the
right.
4. Lower the lever as far as it will go. The threader
will turn and the hook pin will go through the
needle eye.
5. Draw thread into the guide.
6. Hold thread loosely and release the lever.
Hook will turn and pass thread through needle
eye while making a loop.
7. Pull thread out about 10 cm (4 inches) through
the needle eye.