Filter
Top Products
14
REMOVABLE EXTENSION
TABLE
A. REMOVING THE EXTENSION TABLE
Hook your fi nger under the left bottom side of
the removable extension table and slide it to the
left. To attach, push the table to the right.
B. OPENING THE ACCESSORY CASE
Hook your fi nger under the left side of the
accessory drawer cover and pull toward you.
Note:
Your machine’s accessories are stored inside this drawer.
CHANGING THE PRESSER
FOOT
The presser foot must be changed according to
the stitch or technique you sew.
A. CHANGING THE PRESSER FOOT
1. Turn the hand wheel toward you until the needle
is at its highest point.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the presser
foot release lever toward you.
4. Place desired foot with its pin directly under the
slot in presser foot holder.
5. Lower the presser foot lifting lever and the
presser foot will snap into place.
CAUTION: To prevent accidents.
Turn off the power switch before you change
the presser foot.
B. REMOVING THE PRESSER FOOT
HOLDER
When attaching presser feet that have their
own shank, or when cleaning the machine, you
should remove the presser foot holder.
1. Remove the presser foot.
2. Loosen the presser foot screw and remove the
presser foot holder.
3. To replace the holder, pull up the holder as far
as it will go from bottom of presser bar.
4. Tighten the presser foot screw securely using
the screwdriver.