Filter
Top Products
27
Sew 4-step buttonholes
Prepare
Note:
Tips:
1. Take off the all purpose foot and attach the buttonhole foot.
2. Measure diameter and thickness of button and add 0.3 cm (1/8") for bar
tacks; mark buttonhole size on fabric.
3. Place fabric under the foot, so that marking on the buttonhole foot aligns
with starting marking on fabric. Lower the foot, so that the buttonhole
center line marked on the fabric aligns with the center of the buttonhole
foot.
Adjust the stitch length dial in the " " to set stitch density.
Density varies according to the fabric.
Always test sew a buttonhole on the fabric you are using to sew the
buttonhole.
Follow the 4-step sequence changing from one step to another with the stitch
pattern selector dial. Take care not to sew too many stitches in stages 2 and 4.
Use seam ripper and cut buttonhole open from both ends towards the middle.
- Slightly reducing upper thread tension will produce better results.
- Use a backing for fine or stretchy fabrics.
- It is advisable to use heavy thread or cord for stretch or knit fabrics.
- The zig-zag should sew over the heavy thread or cord. (5)
4
2
3
1
0
1
2
3
4
4
1
2 3
5