Filter
Top Products
34
4830 & 4832
Twin needle sewing
Additional accessory
Caution: Make sure not to use a stitch width
greater than that what is recommended when
twin needle stitching.
Recommended settings
Stitch Selection: Desired stitch
Needle Position:
Stitch Width:
Stitch Length: 2-5
Foot: General Purpose (B)
Needle Plate: General Purpose (A)
Procedure
• Turn the machine off.
• Insert the twin needle with the flat side of
the shank toward the rear of the machine.
• Thread the machine as you normally would
for single needle stitching, and pass the
thread through the left eye of the twin
needle
• Insert a second spool pin into the hole on
the top cover of the machine as illustrated.
• Thread the machine in the usual way.
• Pass the thread through the remaining
point, making certain to omit the thread
guide just above the needle and pass
thread through right eye of needle.
• Draw both threads under the foot and back
along with the bobbin thread.
• Slowly lower the needle into the hole in the
needle plate by turning the hand wheel
toward you to make sure the needle clear
the plate.