Filter
Top Products
14
4830 & 4832
Threading the machine
• Raise take-up lever to highest posi-
tion by turning hand wheel toward
you.
• Raise presser foot to release thread
tension.
• Place spool of thread on spool pin.
• Slide spool cap firmly over rim of
spool to prevent thread tangling.
• Lead thread from spool and snap
into thread guide (1) and with only
one hand pass the thread under the
guide and through the slot, as illus-
trated (2)
• Thread the tension discs by leading
the thread down and around the tor-
sion (3). Hold the spool lightly and
pull the thread up, lifting the spring
and allowing the thread to dip into
thread guard.
• Slip thread into take up lever as
illustrated (4).
• Pass thread through guides (5) and
(6).
• Thread needle from front to back,
pulling 4" (10 cm) of thread through
eye (7).